Detail Laporan TA : MUHAMMAD RIFALDI

MUHAMMAD RIFALDI (2019) PERANCANGAN MESIN PIPA ROLL BENDING MENGGUNAKAN SISTEM LINEAR ACTUATOR ELECTRIC Skripsi, Teknik Mesin
Politeknik Negeri Indramayu.

Text LAPORAN BAB 1 ( Download )

There are still many Small and Medium Enterprises (SMEs) in the area around Indramayu that still use pipe roll bending machines manually, so it takes a long time to form a 1/2 inch pipe into a radius. Therefore, a pipe roll bending machine is needed that is faster for 1/2 inch pipe sizes and a design that follows the technological era where all work is done automatically. This study aims to produce a pipe roll bending machine design using a linear actuator electric system with the help of solidworks 2019 software. The design results obtained are with frame dimensions of length 556 x width 406 x height 1094 mm, the type of material used is ASTM A36, the drive source uses a motor electricity with a power of 0.5 HP and a rotation of 1450 rpm is then transmitted by the hub shaft to the gearbox with a ratio of 1:60 producing a rotation of 24.17 rpm and further transmitted by the sprocket and chain with a ratio of ½ resulting in a final rotation of 12.08 rpm. For the electric linear actuator used is a capacity of 900 N. The maximum capacity for rolling pipes is a pipe with a diameter of ½ inch with a thickness of < 1 mm. Keywords: Design, pipe rolling machine, linear actuator electric.